["Medication, Administered": "Oral Factor Xa Inhibitor for VTE Prophylaxis or VTE Treatment"]
Data Element Scope: This value set may use a model element related to Medication.
Inclusion Criteria: Includes concepts that represent a medication for oral forms of factor Xa inhibitors.
Exclusion Criteria: Excludes concepts that represent dose forms of factor Xa inhibitors other than oral.
Constrained to codes in the Medication, Administered: Oral Factor Xa Inhibitor for VTE Prophylaxis or VTE Treatment value set (2.16.840.1.113883.3.117.1.7.1.134)
"Medication, Administered"
Data elements that meet criteria using this datatype should document that the medication indicated by the QDM category and its corresponding value set was actually administered to the patient.
Timing:
- relevant dateTime references the time the medication is administered if it was given or taken at a single point in time.
- relevantPeriod references a start and stop time for medication administration if the administration event occurred over a time interval (e.g., an intravenous infusion). The relevantPeriod addresses:
- startTime - when a single medication administration event starts (e.g., the initiation of an intravenous infusion).
- stopTime - when a single medication administration event ends (e.g., the end time of the intravenous infusion).
- author dateTime references the time the action was recorded.
- Refer to the eCQM expression to determine allowable timings to meet measure criterion.
Notes:
- Measure developers should address multiple administrations over a period of time using CQL logic.
- negation rationale indicates a one-time documentation of a reason an activity is not performed. Negation of QDM datatype-related actions for a reason always use the author dateTime attribute to reference timing and must not use relevantPeriod.
Refer to Special Cases in Section 5.7 for scenarios to consider in calculating cumulative medication duration.
relevantDateTime
relevantPeriod
relevantPeriod addresses the time between the start of an action to the end of an action. Each QDM datatype using relevantPeriod defines specific definitions for the start and stop time for the action listed.
Note: negation rationale indicates a one-time documentation of a reason an activity is not performed. Negation of QDM datatype-related actions for a reason always use the author dateTime attribute to reference timing and must not use relevantPeriod